Notes

Published

Why your watch says 42.6 km

A certified marathon course is measured along the shortest route a runner could legally take. You won't run that route, and your watch measures what you did run, with some GPS error added. So it usually reads long, and if you pace by it you finish later than you planned.

How a course is measured

Road races that are certified to World Athletics and AIMS standards are measured with the calibrated bicycle method. A counter is fixed to the front wheel of a bicycle. The measurer rides a straight calibration course whose length has been taped with a steel tape, which tells them how many counts make a kilometre. Then they ride the race route, and ride the calibration course again afterwards, because the count per kilometre drifts with tyre pressure and temperature.

The route they ride is the shortest possible route: the shortest path a runner could follow within the part of the road that is open for the race. On bends and corners the measurer stays 30 cm from the kerb. Between bends they take the straightest line, crossing from one side of the road to the other when that is shorter. The measurement manual says that any particular runner is most unlikely to follow this route, and tells measurers not to try to measure what they think runners will do. Defining the course this way means every runner covers at least the official distance.

Why you run further

Nobody runs the shortest possible route for 42 km. A few of the reasons:

  • Corners. The measured line clips each corner 30 cm from the kerb. In a crowd you take most corners wider than that.
  • The racing line. The measured route cuts diagonally across the road between bends. Most runners stay on one side, or follow the people in front of them.
  • Weaving. Each time you move out to pass someone and back in again, you add a few metres. In a crowded start this happens constantly.
  • Aid stations and toilets. Drifting to the edge of the road for a drink, then back to the middle, adds distance that the course never included.

None of this is a mistake by the race. The official distance is a minimum, and the extra you run depends on how you run the course.

Why the watch adds more

A GPS watch estimates where you are at regular intervals and joins the points. Every position has some error. Tall buildings, trees, bridges and tunnels make that error larger or interrupt the signal.

The errors don't all go the same way. Joining points with straight lines can cut the inside of a curve and read short. Position noise makes your track zigzag a little from side to side, which reads long. On a long city course these effects, and the real extra distance you ran, often add up to a reading over 42.2 km. A reading of 42.6 km is about 1% over the official distance.

What 1% costs

The watch pace you need to finish on time, and how late you finish if you hold the official pace on your watch.
Goal Official pace Watch pace, 0.5% long Late by Watch pace, 1% long Late by Watch pace, 1.5% long Late by
3:00:004:15.94:14.6+0:544:13.4+1:484:12.1+2:42
3:30:004:58.64:57.1+1:034:55.6+2:064:54.2+3:09
4:00:005:41.25:39.5+1:125:37.8+2:245:36.2+3:36
4:30:006:23.96:22.0+1:216:20.1+2:426:18.2+4:03

Reading the table

Paces are per km and rounded down, so holding the shown pace never makes you late. If you aim for 3:30:00 and hold 4:58.6 per km on a watch that reads 1% long, you cross the line about two minutes after your goal. The two paces differ by only 3 seconds per km, but over a marathon that adds up to about two minutes.

How to pace it

You have two reasonable options.

  • Pace by the official markers. Take a manual lap at each km or mile marker and compare the elapsed time with your split list. The markers are on the measured course, so they stay correct however much extra you run. Write down or print your splits beforehand.
  • Adjust your watch target. If you know your watch tends to read about 1% long on races like this one, aim for the faster watch pace in the table, not the official one.

The splits tool has a "My watch reads long by" setting. It adds a column with the pace your watch will show.

Whichever you choose, run the tangents where it is safe. Look ahead to the next corner and take the straight line towards it, rather than following the curve of the road or the runner in front.

Sources

  • IAAF and AIMS, The Measurement of Road Race Courses, second edition 2004, updated 2008. The calibrated bicycle method, the shortest possible route measured 30 cm from the kerb, the 1.001 factor, and the note that a runner is most unlikely to follow the shortest route.
  • AIMS, Course measurement, which links to the booklet and the measurement forms.
  • The paces and times in the table are calculated with the same code the site's calculators use.